Bradley EXPRESS SS-3/AST/STD Manual de instalación descargar pdf (Pagina 8)

SS-3N/AST/STD, SS-3N/AST/WH Installation

8 12/11/07 Bradley Corporation • 215-1494 Rev. E; ECN 07-814

Connect the Supply — Hot and Cold Supply

The letter “H” on the Vernatherm™ Mixing

Valve indicates hot water supply inlet.

Connect the Supply — Single Tempered Supply

Loosen but do not remove

the two mounting screws

holding the valve bracket

to the frame.

Slide the valve bracket up

and lift it from the frame.

Loosen but do not remove

the two mounting screws

holding the valve bracket

to the frame.

Slide the valve bracket up

and lift it from the frame.

Connect one end of flexible hose

to the tempered line adapter.

Connect the other swivel end to

the stop/check valve.

Using a thread sealer, thread

the stop/check valve onto

the tempered wall stub-out.

Connect one end of each hose to the

Vernatherm™ valve (one on the hot side, one

on the cold side).

Connect the other swivel end to the stop/

check valves.

Using a thread sealer, thread

the stop/check valves onto the

hot and cold wall stub-outs.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Sin comentarios

Bradley EXPRESS SS-3/AST/STD Manual de instalación Pagina 8